Isnin, Jun 03, 2013

Vehicle Sensor



Sensor Circuit Diagram



Here is a typical schematic diagram of the car Throttle Position Sensor Circuit. The Throttle Position Sensor (TPS) is designed to indicates the position of the throttle valve. Usually the Throttle Position Sensor is mounted on the throttle body and converts the throttle valve angle into an electrical signals. Inside the TPS is a resistor and a wiper arm. The arm is always contacting the resistor.



How the Throttle Position Sensor works?

A wiper arm inside the sensor is mechanically connected to a moving part, such as valve or vane. As the part moves, the wiper arm also moves. The wiper arm is also in contact with a resistor. As the wiper arm moves on the resistor, the signal voltage output changes which indicates position.










Fuel Tank Pressure Sensor Circuit with explanation



The control module monitors the fuel tank pressure (FTP) sensor signal in order to detect vacuum decay and excess vacuum during the enhanced evaporative emission (EVAP) diagnostic. The Fuel Tank Pressure Sensor responds to changes in the fuel tank pressure or vacuum. This information is used in order to detect vacuum decay or an excessive vacuum during EVAP diagnostic routing. Thefuel tank pressure sensor signal voltage to the VCM varies from a minimum of about 0.1 volts with pressure in the fuel tank to above 4.0 volts with a high vacuum in the fuel tank.




The following schematic shows the Typical Fuel Tank Pressure Sensor Circuit Diagram.




Tiada ulasan:

Catat Ulasan