WELCOME To PROJECT CIRCUIT DESIGN

Search

Khamis, September 26, 2013

555 Burglar Alarm





The circuit illustrated here is used as an Burglar alarm. LDR is kept at such a place that when thief enters our house then a shadow will fall on the LDR. A small beam of light source is also needed to supply continuous signal to LDR. For best Light source we can use Laser diode which will work for few KMs. For home use Infra Red LED’s will be good and will be tricky to thief and works with same efficiency at night.
This circuit uses a popular timer I.C which is 555. I.C 555 is connected as comparator with pin 6 connected with positive supply, the output goes high-1 when the trigger pin 2 is at lower than 1/3 level of the supply voltage. Conversely the output goes low-0 when it is above 1/3. So small change in voltage of pin 2 is enough to change the output state of pin 3 from 1 to 0 and 0 to 1. The output has only two states high and low and can not remain in any intermediate stage. It is power by 9V battery for portable use. The circuit is economic in power consumption. Pin 4,6& 8 is connected to the positive supply and pin 1 is grounded.
To detect the present robber we have used LDR and a source of light.
LDR is a special type of resistance whose value depends on the brightness of the light which is falling on it. It has a resistance of about 1 megaohms when in total darkness,but a resistance of only about 2-5 k ohms when brightly illuminated. It responds to a large part of the light spectrum.
The source of light and LDR is so adjusted with a reflector that light will directly fall on the LDR but when robber enters inside then it will block the beam of light and LDR will be under darkness.
We have made a potential divider circuit with LDR and 100 K variable resistance connected in series. Voltage is directly proportional to conductance so more voltage we will get by this divider when LDR is getting light and low voltage in darkness. Sensitiveness can be adjusted by variable resistance. Divided voltage is given to pin 2nd of 555. As soon as LDR gets dark the voltage of the pin 2 drops 1/3 of the supply voltage and pin 3 gets high and Buzzer Beeps.
For Demo we have used simple LED for LED1 may be Red or White Color


Circuit Diagram of Burglar Alarm

LED = Light Emitting Diode
LDR = Light Dependent Resistance
IC = Integrated Circuit

Components:-
  1. 9V battery with snap
  2. LDR
  3. Variable resistance 100K ohms
  4. Resistance 470 ohms
  5. LED
  6. IC 555
  7. Switch

1 ulasan:

  1. You have provided an nice article, Thank you very much for this one. And i hope this will be useful for many people.. and i am waiting for your next post keep on updating these kinds of knowledgable things...

    Home Automation in Chennai
    smart home in Chennai
    Home security in Chennai
    Burglar alarm in Chennai
    Wifi Camera Chennai

    BalasPadam

Popular Project

Another Project Blog

Project From Diff Blogger

Links

How to Find the other Websites of a Person?


DomainTools

Whois Source Logo



BetterWhois.com: Search ALL Domain Registrars

Webcams.travel - The Webcam Community - Home




Terdapat ralat dalam alat ini

Web_Cams_Travel